After Each Use; Nozzle Cleaning - Vevor Xs-18Inxdj Mode D'emploi

5. Walk slowly behind the unit, cleaning as you go. If striping occurs, slow
down the pace. Do not allow machine to remain stationary on soft surfaces
such as wood.
SHUT-DOWN
1. Turn the Pressure Washer off.
2. Turn the water supply off.
3. Squeeze the trigger gun to relieve water pressure.
4. Disconnect and drain the water hose and wipe down unit. Store the unit
in a dry environment.

AFTER EACH USE

Perform the following inspections after each use to clean the cleaner and
ready it for the next use.
• Clean out any dirt or foreign material from under the housing and the
casters. If necessary,use a cloth or sponge to wash the surface cleaner
and rinse it with tap water.
• Check for loose parts and any damage.

NOZZLE CLEANING

See Fiqure3.
Excessive pump pressure (a pulsing sensation felt while squeezing the
trigger) OR inadequate cleaning power may be the result of a clogged or
dirty nozzle
1.Turn off the pressure washer and shut off the water supply.Pull trigger to
release water pressure and disconnect surface cleaner from high pressure
hose.
2.Using a wrench, remove the nozzle from the spray bar.Using a nozzle
cleaner (provided) to clean the nozzles.
3.Using a garden hose, fush debris out of nozzle by back flushing(running
the water through the nozzle backward or from the outside to the inside).
4.Reconnect the nozzle to the spray bar and tighten it securely.
- 8 -