Makita 2704 Manuel D'instruction page 14

Spindle
CUT
WIDTH
1/8"
1/4"
5/16"
3/8"
7/16"
1/2"
9/16"
5/8"
11/16"
3/4"
13/16"
CAUTION:
• For a 1/8" cut width, the outside cutter is assembled
to the spindle in the same manner as the saw
blade.
• The outer flange must be used for each cut width.
• The hex nut alone must not be used to secure the
dado on to the spindle.
NOTE:
• When widths slightly greater than the above are
required, fit the paper washers in between the
inside and outside cutters to adjust the width.
Outside
Inner
Inner
Cutter
flange
flange
1/8"
1/16"
Outside
Inside
Inside
Cutter
cutter
cutter
x2
x2
x3
x3
x4
x4
5. Arrange the cutters so that the tips of the inside cut-
ters are positioned at the gullets of the outside cut-
ter. When more than one inside cutter is used,
space the tips of the inside cutters equidistantly in
relation to one another. Poorly spaced cutters may
cause vibration and noise.
1
2
14
006177
Outer
Hex
flange
nut
006178
1. Outside cutter
3
2. Inside cutter
3. Gullet