Publicité
Les langues disponibles
Les langues disponibles
Install rear wheel
1. Remove the nuts (2pcs) from the rear axle.
2. Passing the rear axle through the body. Make sure the rear axle is
positioned evenly on each side. Install the drive motors "L" and "R" on the left
and right sides of the rear axle respectively.
3. Place a bushing on the inside of the wheel. Align the wheel driven connector
with the screw hole of the wheel, use 3pcs of M4*12mm round head screws to
fix. (Total installed two wheels according to these steps)
4. Slide a wheel with driven connector onto the rear axle, place a M12 washer
and finally fix it with a nut. Snap on a wheel cap. Repeat on the other side.
NOTE: Use two plastic wrenches (one on each side) and rotate in opposite
directions to tighten nuts.
Connect the motor wiring and power cord
1. Flip the car onto its wheels, within the seat, plug the connectors for the left
and right drive motors into the designated terminals on the circuit board.
2. Insert the connector from the battery into the designated terminal on the
circuit board.
NOTE: Make sure the connector is oriented correctly to fit into the terminal.
10
Install side armrest
1. Insert the 2 side armrests into
the car body.
11
Publicité
