Customer Service - Klein Tools 93Rls Manuel D'utilisation

ENGLISH
OPERATING INSTRUCTIONS
RECHARGING BATTERY
When the Red LED on the Battery Level Indicator blinks, the battery needs to be recharged:
1. Connect supplied charging cable's
93RLS.
2. Connect the charging cable's USB-A port to a charging source (5V DC, Min 2.0A, not
included).
3. The Battery Level Indicator 10 will illuminate to indicate charging status (TABLE 1).
4. A full charge can take up to 8.5 hours, depending on the charger's output. Charge
completely before using.
Not
Green
Illuminated
LED Status
Solid green
Solid green
Solid yellow
Solid red
Blinking green
Solid green
Solid yellow
Solid red
Not Illuminated
Blinking green
Solid yellow
Solid red
Not Illuminated
Not Illuminated
Blinking yellow
Solid red
Not Illuminated
Not Illuminated
Not Illuminated
Blinking red
8
12
USB-C connection to the USB-C port
TABLE 1
Yellow Red Blinking
% Charged
100% charged
75% to 99% charged
50% to 74% charged
25% to 49% charged
0% to 24% charged
If at any time the Rotation Speed Indicators
second pause, contact Klein Tools Customer Service for assistance. DO NOT ATTEMPT
TO REPAIR THE UNIT.
6
of the
• Regularly inspect ports and charging cable for and debris, dirt, damage, and corrosion.
• DO NOT attempt to repair device or cable; replace as needed.
Be sure instrument is turned off and disconnected from all power sources. Wipe with
a clean, dry lint-free cloth. Do not use abrasive cleaners or solvents.
Recharge as needed. There are no pre-designated intervals at which to recharge as
long as you are using the unit regularly. Avoid discharging completely on a regular
basis, as this can impact overall life.
If storing for more than one month, charge completely before storage, and recharge
approximately every three months to avoid full discharge. Store in cool temperatures, mild
humidity, and away from direct sunlight (See GENERAL SPECIFICATIONS section).
Leaving in a vehicle or other confined spaces in extreme hot temperatures can lead to decrease
in service life, overheating, or fire. Extreme cold temperatures below the specified storage range
can also harm performance and service life. Keep away from corrosive chemicals and gases.
After taking out of storage, inspect visually to make sure device and all accessories look
satisfactory. Allow unit to return to ambient conditions before recharging.
Do not place equipment and its accessories in the trash. Items must be
properly disposed of in accordance with local regulations. Please see
www.epa.gov/recycle for additional information.
450 Bond Street Lincolnshire, IL 60069 1-800-553-4676
customerservice@kleintools.com
TROUBLESHOOTING
3
blink multiple times separated by a one-
MAINTENANCE
CLEANING
RECHARGING
STORAGE
WARRANTY
www.kleintools.com/warranty
DISPOSAL / RECYCLE

CUSTOMER SERVICE

KLEIN TOOLS, INC.
www.kleintools.com
9