Cleaning Spark Arrestor Screen - Honeywell HW5600C Guide D'utilisation

Cleaning Spark Arrestor Screen

Cleaning Spark Arrestor Screen
WARNING
Muffler reaches temperatures that can cause serious
burns if touched. NEVER touch hot surfaces.
Generator muffler is equipped with spark arrestor screen,
which must be cleaned according to maintenance sched-
ule (Table 2).
To clean spark arrestor screen, you will need:
‰ 1/4" socket wrench
‰ 8 mm socket
‰ 7/32" socket
‰ #2 Phillips screwdriver
‰ Wire brush
1. Stop generator if engine is running. Allow to com-
pletely cool.
2. Place the generator on a flat, level surface.
Using a socket wrench with 8 mm socket, remove the
3.
muffler cover bolts.
4. Remove muffler cover.
FIGURE 45: Remove Muffler Cover
Loosen the spark arrestor clamp screw (A) with a
5.
Phillips screwdriver.
A
B
FIGURE 46: Spark Arrestor Assembly
Remove spark arrestor clamp.
6.
24 www.honeywellgenerators.com
C
7. Remove the spark arrestor screen cover (B) screw
with a socket wrench and a 7/32" socket.
Remove the spark arrestor screen (C).
8.
9. Inspect spark arrestor screen.
„ If screen is damaged or excessively worn, replace
with new screen.
„ If screen is in good condition, clean using wire
brush and then reinstall.
FIGURE 47: Clean Screen
10. Reinstall remaining spark arrestor components care-
fully aligning screw holes.
„ Screen cover and screw
„ Clamp and screw
„ Muffler cover
HW5600C Portable Electrical Generator Owner's Manual