Assembly
Step 2: Install Wheel Axle and Wheels
To install wheel assembly, you will need:
Wheel axle (1)
M10 x 16 mm long full-thread hex bolts (4)
M13 serrated flange nuts (4)
*
Axle bracket
(1)
Wheels (2)
M16 x 30 mm OD x 2.5 mm washers (2)
Snap pins (2)
10 mm open end wrench
Socket wrench with 13 mm socket
* Two brackets are needed to install wheel axle. One bracket
comes already attached to wheel axle; other bracket is included
in accessory kit box.
† Not included.
Install wheel axle brackets to frame using 16 mm long
1.
full-thread hex bolts and serrated flange nuts.
Install pre-attached bracket to frame first.
1A.
NOTE:
Axle brackets are offset (one side longer than the other),
place with the short side up during installation.
Install other bracket to frame.
1B.
FIGURE 8: Wheel Axle Attached to Generator
8
www.honeywellgenerators.com
†
†
On each end of axle:
Slide and push wheel onto axle until it fits snug
2.
against washer.
FIGURE 9: Slide Wheel onto Wheel Axle
Slide a washer onto axle.
3.
Slide snap pin into pre-drilled hole until fully seated.
4.
FIGURE 10: Snap Pin Installation
Return generator to upright position (so that wheels
5.
and leg supports are touching the ground).
HW5600C Portable Electrical Generator Owner's Manual