Step 3: Install Handle Assembly
To install handle assembly, you will need:
Handle bars with brackets (2)
Rubber handle grips (2)
40 mm long carriage bolts (4)
M10 acorn nuts (4)
10 mm open end wrench
* Not included
Slide rubber handle grip onto each handle bar and tap
1.
on hard surface until fully seated.
FIGURE 11: Attach Grips to Handle
Hold handle bracket over pre-drilled holes on frame
2.
as shown in Figure 12.
FIGURE 12: Handle Bracket to Frame
Attach bracket to frame using carriage bolts and
3.
acorn nuts then tighten.
HW5600C Portable Electrical Generator Owner's Manual
*
Confirm the handle bar is securely fastened to the
4.
bracket as it may have loosened during shipping.
FIGURE 13: Tighten Handle Bar Bolt
CAUTION
Hands and fingers can be pinched from collapsible
handles.
• Keep hands and fingers clear from hinges when
collapsing generator handles.
• Handles should only be used to roll the generator to a
new location. If lifting the generator (i.e. into a vehicle),
never use the handles to support the complete weight
of the generator.
•
To collapse handles, push in the locking pin and
adjust the handle downward until it rests vertically
against the generator frame.
•
To return handles to horizontal position, push in
the locking pin and pull up on handle until the locking
pins lock in place.
www.honeywellgenerators.com
Assembly
9