Honeywell HW5600C Guide D'utilisation page 13

Step 1: Install Support Legs
To install support legs, you will need:
‰ M8 x 28 mm long full-thread hex bolts (2)
‰ M10 serrated flange nuts (2)
‰ M10 x 16 mm long full-thread hex bolts (4)
‰ M13 serrated flange nuts (4)
‰ Brackets (2)
‰ Rubber stoppers (2)
‰ Socket wrench with 10 mm socket
* Not included
CAUTION
Generator must be empty of engine oil and fuel.
Drain engine oil and fuel, if necessary.
Generator is heavy! Lifting generator can cause
back or other bodily injury. NEVER lift generator
without assistance.
1. Place the generator on a flat, level surface.
Stand at side of generator opposite recoil starter
2.
handle. Grip frame; carefully pull up and push to tilt
generator backward.
FIGURE 5: Tip onto Generator Recoil Side
Gently set generator onto the recoil side or elevate
3.
the generator by placing solid wood pieces under-
neath unit.
HW5600C Portable Electrical Generator Owner's Manual
4.
*
5.
Attach a rubber stopper to the bottom of each support
leg using a 28 mm long full-thread hex bolt and ser-
rated flange nut; tighten until securely seated.
FIGURE 6: Rubber Stopper Attached to Support Leg
Attach each support leg to pre-drilled holes on bottom
of generator frame, using 16 mm long full-thread hex
bolts and serrated flange nuts; tighten until securely
seated.
FIGURE 7: Support Leg Attached to Generator
www.honeywellgenerators.com
Assembly
7