Safety Edge Wiring - Somfy Rollixo Optimo Rts Manuel D'installation

Rollixo Optimo RTS
WARNING
The earth wire must always be longer than the live and neutral to ensure that it is the last to be disconnec-
ted if the connector is pulled out.
The cable clamp supplied must be used.
For all low-voltage cables, ensure that they can withstand traction of 100 N. Check that the conductors do
not move when this traction is applied.
3.5

Safety edge wiring

DANGER
Wiring a safety edge is compulsory.
The operation must be carried out with the power off.
3.5.1 Connect the safety edge
Optical wired safety edge
> > > Illustration 8
Translation of the colours present on the safety edge wiring diagram:
EN EN
Brown Brown
Green Green
White White
Wired resistive safety edge 1.2 kΩ or 8.2 kΩ.
> > > Illustration 9
3.5.2 Adjust setting P2 according to the type of safety edge connected
1] Press the "SET" button for 0.5 s to enter parameter setting mode.
ð Indicator light P0 flashes once.
2] Press the "SET" button twice to move on to parameter P2.
ð Indicator light P2 flashes once to indicate the value selected.
3] Press the "+" or "-" button to change the value of the parameter.
ð The indicator light flashes x times to indicate the value selected.
• P2 = 1 x: Optical wired safety edge
• P2 = 2 x: Resistive wired safety edge 1.2 kΩ
• P2 = 3 x: Resistive wired safety edge 8.2 kΩ
4] Press the "SET" button for 2 s to confirm a value and exit parameter setting mode.
ð The parameter setting indicator lights go out.
©
Copyright 2019 SOMFY ACTIVITES SA. All rights reserved.
EN
33