Switch And Indicator Unit - Zanussi ZFT 710 W Notice D'utilisation

accessories of the adjustable feet. If levelling the
appliance requires, these washers can be removed.
Do not stand the appliance on a sunny place or close
to a radiator or cooker.
If it is unavoidable because of furnishing and the appli-
ance has to be stood near a cooker take these mini-
mum distances into consideration:
In case of gas or electric cooker 3 cm must be left,
when it is less put a 0,5 - 1 cm non-flam insulation
between the two appliances.
In case of oil or coal-fired stove the distance must
be 30 cm since they give off more heat.
The refrigerator is designed to operate when it is total-
ly pushed to the wall.

Switch and indicator unit

For the usage of the switching and indicator unit see
chapters "Putting it into use", "Controlling the temper-
ature" and "Freezing".
Components of the appliance are as follows:
A) Green indicator lamp
This lamp lights when the appliance is under
power, i.e. the mains plug is in the mains socket.
B) Red indicator lamp
It lights up depending on the temperature inside
the appliance.
It lights for a short time when starting the appli-
ance, placing fresh food into it and when the tem-
perature control knob has been turned in direc-
tion to lower temperatures.
It lights permanently when the temperature inside
the appliance is too high (overloaded with warm
food, door stayed open or the door seal does not
close properly) or possibly the appliance was bro-
ken down.
When placing the refrigerator keep minimal dis-
tances recommended in figure.
A: placing it under a wall-cupboard
B: placing it freely
C) Yellow indicator lamp and freezer switch
In the switched-on state of the switch (pops up
and lights by pressing) the compressor operates
continuously thus providing for the coldest interior
temperature - achievable by the freezer - needed
for freezing.
D) Temperature control knob
This knob is provided for setting and changing the
temperature inside the appliance.
39