cecotec PrecisionCare OneShave Screen Manuel D'instructions page 104

ENGLISH
USB charge
- This appliance is equipped with a built-in battery that takes 1.5
hours to fully charge and provides approximately 100 minutes
of autonomy.
- To charge the appliance, use the USB cable provided.
Removing the rechargeable battery
If you wish to dispose of the appliance, you must remove the
rechargeable battery. Before removing it, make sure that the
appliance is disconnected from the power supply and that it is fully
discharged. Take the necessary safety precautions when using
tools to open the appliance and when disposing of the battery.
104
PRECISIONCARE ONESHAVE SCREEN
1. Check the front and rear of the appliance for screws. If there
are any, remove them.
2. Use a screwdriver to remove the front and rear panel of
the appliance. Remove all necessary parts until you see the
printed circuit board that holds the battery.
3. Remove the battery.
4. CLEANING AND MAINTENANCE
- Turn off and unplug the appliance before cleaning it.
- Clean the outside of the appliance with a damp cloth.