cecotec PrecisionCare OneShave Screen Manuel D'instructions page 103

Operation
7. Point the guide comb towards the hair and guide the appliance
in the direction of hair growth.
- Removing the guide combs
1. Make sure that the appliance is switched off before removing
the guide combs.
2. With one hand, hold the base of the shaver firmly.
3. Using your other hand, grasp the guide comb by the sides.
Gently lift the guide comb up and out of the shaver head. Be
sure not to apply too much force to avoid damaging the guide
comb or the shaver.
4. Once you have removed the guide comb, you can proceed to
clean it if necessary.
Recommendations:
- The length of the cut may vary depending on the trimming
angle. Start with a longer guide-comb setting and progressively
shorten the cutting length as the hair is cut.
- To prevent hair from clogging the guide comb, clean it regularly
with a brush.
Note: this appliance can be used with or without a cable.
PRECISIONCARE ONESHAVE SCREEN
ENGLISH
103