cecotec PrecisionCare OneShave Screen Manuel D'instructions page 102

ENGLISH
Guide combs
The 3 guide combs provided allow you to adjust the cutting length
(from 1 to 5 mm).
- Guide combs installation
1. Make sure that the appliance is switched off before attaching
or handling the guide combs.
2. Choose the right guide comb according to the desired cutting
length.
3. Hold the shaver with one hand and the guide comb with the
other. Align the guide comb so that it is in the correct position
to be attached to the shaver head.
102
PRECISIONCARE ONESHAVE SCREEN
4. Fit the guide comb into the base by first placing the lower part
of the guide comb into the base of the shaver head. Make sure
that the grooves on the guide comb match the tabs on the
shaver.
5. Once the lower part is in place, press the upper part of the
guide comb down until you hear a "click". This ensures that the
guide comb is correctly installed and will not move during use.
6. Check that the guide comb is firmly attached to the shaver. Try
to move it gently to make sure it does not come loose.
Note: do not force the guide comb into place; if resistance is
encountered, realign and repeat the steps.