Environmental Recommendations - Adeunis RF sigfox TEMP Guide Utilisateur

sigfox TEMP- Guide utilisateur / User guide version V1.2.0

ENVIRONMENTAL RECOMMENDATIONS

All superfl uous packaging materials have been eliminated. We have done everything possible to make it easy to separate the packaging into
three types of materials: cardboard (box), expanded polystyrene (fi ller material) and polyethylene (packets, foam protective sheets). Your device
is composed of materials that can be recycled and reused if it is dismantled by a specialist company. Please observe local regulations concer-
ning the manner in which waste packaging material, used batteries and your obsolete equipment are disposed of.
WARNINGS
Valid for products indicated in the declaration of conformity
Read the instructions in the manual.
The safety of this product is only guaranteed when it is used in accordance with its purpose. Maintenance should only be carried out
by qualifi ed persons.
Please note: Do not install the equipment close to a heat source or in damp conditions.
Please note: When the equipment is open, do not carry out any operations other than the ones set out in this document.
Please note: Do not open the product as there is a risk of electrical shock.
Please note: For your own safety, you must ensure that the equipment is switched off before carrying out any work on it.
Please note: For your own safety, the power supply circuit must be SELV (Safety Extra Low Voltage) and must be from limited power
sources.
Please note: When the aerial is installed outside, it is essential to connect the cable screen to the building's earth. We recommend
using lightning protection. The protection kit chosen must permit the coaxial cable to be earthed (eg: coaxial lightning arrester with earthing
of the cable at different places on the aerial at the base of pylons and at the entrance, or just before entering the premises).
The product must be equipped with a switching mechanism so that the power can be cut. This must be close to the equipment. Any electrical
connection of the product must be equipped with a protection device against voltage spikes and short-circuits.
EN
Page 41 of 72