Pioneer SP-SB23W Instructions D'utilisation page 8

8
English
hOw tO CONNECt YOUR SPEAkER BAR AND
SUBwOOFER tO YOUR tV
the simplest approach is to connect the optical audio output of your tv to the optical input on the
back of the bar. this method will provide the highest quality audio regardless of whether you are
watching tv or watching your favorite optical disc player. if your tv does not have an optical output,
you can use the optical output from your dvd player or your cable/satellite box to connect to the
optical input on the bar. then simply use the other bar inputs for your other audio sources.
hOw tO PAIR YOUR SUBwOOFER tO thE SPEAkER BAR
Make sure that both the speaker Bar and
subwoofer are plugged into an ac outlet.
1. power on the speaker bar
2. press and hold the sync button on the rear of
the speaker Bar until the sync Led begins to
flash red rapidly
3. press and hold the sync button on the rear of the
subwoofer until the blue Led begins to flash rapidly.
4. after a couple of seconds both sync Leds should
become solid blue.
5. if the Leds continue to blink then move the
subwoofer closer to the speaker Bar.
CONCERNINg thE PlACEmENt OF thIS SYStEm
CAuTION
When assembling the system, lay them down flat on
their side to avoid accidents or injury. Make sure to
use a stable surface when assembling, setting up,
and placing the system.
WHErE TO LOCATE YOur BAr FOr THE BEST SOuND
correct placement is important for maximizing the sound
quality of your speaker Bar. take time to experiment
with positioning according to these guidelines.
the speaker bar may be positioned above or below
the tv. For best results align the front of the speaker
bar with the front of the tv.
due to the well-controlled vertical directivity, it is not
normally necessary to vertically aim the loudspeaker
towards the listener. if, however, the speaker bar is
placed under the tv and very close to the floor, then
tilting upwards may be beneficial.
to achieve optimum audio performance, place the
main unit beneath the television monitor.
USINg thE RUBBER FEEt wIth thE SPEAkER BAR
included in the sp-sB23W speaker Bar carton are
(2) feet for the speaker bar to rest on. place the
feet at the desired location of the speaker. they can
be spaced a variety of widths apart for installation
flexibility. once placed on the feet, tilt the speaker to
the desired angle, depending on the location of the
speaker in relation to the desired listening position.
At least 20"apart
NOTE: spacing between the rub-
ber feet should be at least
20 inches apart to avoid the
speaker Bar from tipping over
NOTE: do not use adhesive or
screws to attach the feet to the
speaker. doing this will damage
the cabinet and void the warranty.
speaker Bar
subwoofer