Filling The Pool With Water; Maintenance Instructions - Bestway Carrefour Od161796 Manuel D'utilisation

GB
Assembly of this pool can be completed without additional tools. Installation takes approximately 40 minutes with 2-3 people,
excluding any preparations or water filling (refer to the package for specific information about your purchased item). Please
note that assembly times may vary based on pool size and individual experience.
Carrefour is not responsible for damage caused to the pool due to mishandling or failure to follow these instructions.
Helpful Installation Tips:
We strongly suggest opening the package and assembling the pool when the ambient temperature is above 15°C / 59°F. The
PVC material of the liner will be more flexible and easier to assemble in this environment.
We suggest you buy a pool ladder (if one is not included in the set) and prepare it before setting up the pool, as it will help
whenever you need to get inside it.
Step 4: The vertical legs must be inserted between the liner and the belt before attaching the T-connectors. The legs must be
perpendicular to the ground in two directions.
Step 5: Fully extend the support sleeves on the bottom of the liner to ensure the correct positioning of the U supports.
Step 6: When the pool is filled with around 0.01 m of water, gently smooth out the bottom liner to remove all folds. We
recommend starting from the center of the pool and continuing outwards. You can continue to fill the pool when the floor is
smooth and wrinkle-free.
Step 9: Check the position of the vertical legs at times while filling the pool with water. The legs can gradually change position
due to increased water weight. If the legs are not perpendicular to the ground, please stop filling the pool and adjust them. It
will help with weight distribution to avoid strain on the frame and liner.

Filling the Pool with Water:

ATTENTION: Do not leave the pool unattended while filling with water. Continuously check the pool to ensure it is being filled
correctly. Make sure the vertical legs are always perpendicular to the ground and not under the liner or leaning to the side.
Ensure that the belt of the U-Support is completely extended.
It is highly recommended to use tap water for filling to minimize unwanted content, such as minerals. Do not use sea water.
Fill the pool with water after all assembly steps are completed and until the water reaches the welding line, which
corresponds to 90% of the full capacity. Do not overfill as this could cause the pool to collapse. In the case of heavy rainfall,
we strongly recommend reducing the water level to keep it at 90% capacity and avoid the overflow of water.
IMPORTANT: When the pool is 90% full, check that the distance between the water surface and the top of the rails is the
same all around. If it is different, it means that the surface is not level, and we strongly recommend draining the water and
adjusting the chosen location. Never attempt to move the pool with water still in it.
IMPORTANT: Keeping the pool full of water on unlevel ground can cause the bursting of welding points and/or pool collapse,
causing serious personal injury and/or damage to property. Your pool may contain a great deal of pressure. If your pool has a
bulge or uneven side, the sides may burst, suddenly releasing water and causing serious personal injury and/or damage to
property. When the pool is 90% full, check the pool for any leaks at the valves or seams and for any evident water loss. Do not
add any chemicals to the water until this has been done.

MAINTENANCE INSTRUCTIONS

Keeping your pool water clean and chemically balanced is necessary. Simply using the filtration system and cleaning the filter
cartridge is not enough for proper maintenance of the water.
It is important to prioritize the maintenance and health of your pool water. If you do not adhere to these guidelines, your and
your family's health might be at risk.
Water Maintenance:
We recommend you use pool chemicals to maintain water chemistry and chlorine or bromine tablets (do not use granules)
with a chemical dispenser.
The chemical maintenance with chemical tablets must be performed with a chemical dispenser or chemical floater. Do not
throw chemical products directly into the water. The chemicals will settle on the bottom of the pool and damage and discolor
the liner. In the worst cases, it will damage the structure of the pool liner.
Pool damage resulting from the misuse, number of users and overall mismanagement of pool water is not covered by
the warranty.
Water quality is directly related to frequency of use, number of users and overall maintenance of the pool. The water should
be changed every 3 days if there is no chemical treatment being performed with the water. We recommend that you take a
shower before using your pool, as cosmetic products, lotions and other residues on the skin can quickly degrade water quality.
Place a bucket of water next to the pool to clean users' feet before they enter the water.
Chemical Usage:
We recommend maintaining your water's chemical balance as shown in the table below.
Exceeding the following parameters can damage the structure of the liner and create a dangerous situation for the users.
40