Telic STD32 Mode D'emploi page 32

Configuration call
Wait until the GSM LED is flashing. Now take the mobile phone
with which you want to control the STD32 and call the phone
number of the SIM card which is inside the STD32. The STD32
will accept the call and cancel it a few seconds later. During
this call, a four digit DTMF sequence is send to the caller and
you will hear them on your mobile phone. With this call the
STD32 is configured to the mobile phone. Pay attention that
your mobile phone is transmitting the phone number which
means that the GSM functions "incognito" or "private call" are
disabled. You can change this configuration by inserting the
SIM card into a mobile phone. To test the setting you can call a
different mobile phone; there your phone number or name
should be displayed.
In case the STD32 will be separated from the power supply by
a power failure it will automatically send a SMS with the text
„START-UP ALARM" to the preconfigured telefone number as
soon as the power supply is established again.
Note: The red LEDs of the STD32 will blink cyclically as
long as the STD32 is not configured by a configuration call
or a SMS (factory setting). After 3 minutes the device is
switching off. If you switch it on again afterwards the
STD32 is again expecting the configuration.
32