Telic STD32 Mode D'emploi page 31

General
STD32 basically could be configured with following two
methods:
1. Configuration call ("Easy Setup")
When STD32 is supplied with power for the first time then it can
be configured through a phone call within the first 3 minutes of
power supply. Thereafter STD32 saves the number of the
mobile phone it is being called from (only if the number is being
transmitted) and in future sends the SMS of the events to this
number. You can also switch one relais through a simple call
from this 'known' number to the STD32.
The STD32 can be configured through call from this number for
simple activities. You don't need to use a computer or send
SMS to perform these activities.
2. Configuration through SMS ("Professional Setup")
For complex tasks, such as switching both outputs,
configurating additional phone numbers which are allowed to
trigger an output or receive alarm messages, changing
standard text, changing input pulse time and many other
complex parameters the STD32 can be very easily
programmed through a simple SMS.
In case you want to reset STD32 to factory settings to be e.g.
able to make a new configuration call this is also possible
through SMS.
Please refer to "SMS commands" for configuration through
SMS.
31