POWER BURST
- Installing the battery
5
LINK jack: This jack lets you use a commercially available 3.5 mm mini-phone cable to connect to
another VOX effect pedal that also has a LINK jack. When multiple pedals are connected, turning
one effect pedal on bypasses the other pedals (link function). Use this function as a simple
switcher between other effect pedals in this series.
You can connect up to five units. Do not connect any more than this. If you want to connect
multiple units, use a commercially available splitter cable (you can also use a stereo head-
phone splitter cable). However, you cannot use a splitter cable that divides stereo into L and
R.
Do not make connections using a cable that has a built-in resistor. Doing so might cause mal-
functions.
6
DC 9V jack: Connect an AC adapter (9 V,
Since this effect pedal requires high current consumption, we recommend that you use the AC
adapter.
7
BOOST knob: Adjusts the amount of boost.
8
Mode switch: Selects one of three modes.
TREBLE: Emphasizes the upper frequency range.
NATURAL: Provides a natural tube sound.
MIDDLE: Emphasizes the midrange frequencies.
1
Open the battery cover located on the bottom of the unit.
2
Attach the battery to the battery clip, ensuring that the polarity is correct.
3
Install the battery and close the battery cover.
When the battery runs low, the display indicates "LOW BATT". Install a new battery as soon as possi-
ble. When the battery is completely depleted, the display goes dark and the sound is no longer output.
Turn off the power before installing a battery.
Remove the battery from the unit immediately if it is depleted. Leaving a depleted battery in
the unit might damage the unit (due to battery leakage or other causes). The battery should
also be removed if you won't be using the unit for an extended period of time.
A battery is not included. You must purchase a commercially available 9 V alkaline battery
(6LF22/6LR61).
Installing the battery
3
, 600 mA or greater, sold separately) here.