Depth Adjustment - Makita DFS250 Manuel D'instruction

Depth adjustment

1
Fig.7
► 1. Locator
The depth can be adjusted by turning the locator. Turn
it in "B" direction for less depth and in "A" direction for
more depth. One full turn of the locator equals 2 mm
(1/16") change in depth.
For DFS250
3 mm (1/8")
Fig.8
► 1. Locator
For DFS251
3 mm (1/8")
Fig.9
► 1. Locator
Adjust the locator so that the distance between the tip
of the locator and the screw head is approximately 3
mm (1/8") as shown in the figures. Drive a trial screw
into your material or a piece of duplicate material. If the
depth is still not suitable for the screw, continue adjust-
ing until you obtain the proper depth setting.
A
A
B
Hook
CAUTION:
B
hanging the tool with the hook.
CAUTION:
or on potentially unstable surface.
Fig.10
► 1. Hook
The hook is convenient for temporarily hanging the tool.
1
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
For DFS250
1
Fig.11
► 1. Locator
7 ENGLISH
Always remove the battery when
Never hook the tool at high location
Always be sure that the tool is
1
1