Weller PYROPEN WP 60 Manuel D'utilisation page 21

HOW TO USE AS A TORCH
1.
Knurled nut
ON OFF
1. Loosen and remove tip by turning the knurled nut to right as
shown above.
2. Make sure gas control lever be at the middle.
3. Push gas open switch up.
4. Ignite as shown above with a lighter.
5. Adjust the flame height by moving gas control lever between left /
right.
HOW TO CHANGE EJECTOR UNIT
.
1. 2.
ON OFF
Ejector unit
TROUBLE SHOOTING
Trouble: Problem cause:
Does not ignite 1. Empty gas
2. Ejector unit breakage,
clogging, or used up
3. Gas pressure too
high or too low
Tip does not heat 1. Used up catalyst
2. Insufficient gas
pressure
. .
2. 3. 4. Gas control
lever
ON
Gas open
lever
Change ejector unit when gas does
not flow.
Pull ejector unit upward, then the unit
will come off.
Insert new ejector unit and push the
unit down till fixed.
Problem cause:
1. Empty gas
2. Ejector unit breakage,
clogging, or used up
3. Gas pressure too
high or too low
1. Used up catalyst
2. Insufficient gas
pressure
OFF
21