amzchef FS-IRC119 Manuel Utilisateur page 14

Troubleshooting
Problem
The hob cannot be
turned on.
The touch controls
are unresponsive.
The touch controls
are difficult to
operate.
The glass is being
scratched.
Some pans make
crackling or clicking
noises.
The induction hob
makes a low
humming noise
when used on
a high heat setting.
Fan noise coming
from the induction
hob.
Possible causes
No power.
The controls are locked.
There may be a slight film of
water over the controls or
you
may be using the tip of your
finger when touching the
controls.
Rough-edged cookware.
Unsuitable, abrasive scourer
or
cleaning products being
used.
This may be caused by the
construction of your
cookware
(layers of different metals
vibrating differently).
This is caused by the
technology of induction
cooking.
A cooling fan built into your
induction hob has come on
to
prevent the electronics from
overheating. It may continue
to
run even after you've turned
the induction hob off.
What to do
Make sure the hob is
connected to the power supply
and that it is switched on.
Check whether there is a power
outage in your home or area. If
you've checked everything and
the problem persists, call a
qualified
technician.
Unlock the controls. See section
'Using your induction cooktop' for
instructions.
Make sure the touch control area
is dry and use the ball of your
finger when touching the controls.
Use cookware with flat and
smooth bases. See 'Choosing the
right cookware'.
See 'Care and cleaning'.
This is normal for cookware and
does not indicate a fault.
This is normal, but the noise
should quieten down or
disappear completely when you
decrease the heat setting.
This is normal and needs no
action. Do not switch the power
to the induction hob off at the wall
while the fan is running.
14