Cequent Performance Products Rola Pick-Up-Rack Mode D'emploi page 4

Please read all instructions carefully before assembly, installation and/or use of this product.
4
Under cover
• Remove end cap and under cover from both ends
of crossbars.
5
• Place crossbar onto Vertical Supports and center side-to-side.
• Be sure to align the Adapter Blocks with the Vertical Supports Flanges.
•
Mark with pencil the crossbar location on each side of Vertical Support Flange for under cover installation.
6
"X"
Bottom view of crossbar
•
Remove crossbar from vertical supports. Remove adapter blocks from crossbars.
• Measure distance "x" from pencil marks to end of slot as shown above.
• Cut inner under cover to length first (rounded end), then cut outer under cover to length.
•
Install under covers, 3/8 x 1.25 carriage bolts, adapter block and end cap to both ends of crossbars as shown.
Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
Slot
Pencil marks
"X"
Product Name:
Pick-Up-Rack™
Product Code:
End cap
•
Install Adapter Blocks into each end of crossbar.
Adapter Block
Inner under cover
Page 4 of 6
59742
Mark
Flange
Outer
under cover
59742N Rev D
Printed in China
Mark
4-24-13