Accessories - GMV GL MRL–MC Manuel D'installation

4.3 DOOR OPERATOR
Secure the door operator
fixing brackets (1) to the
guides on the roof by using 4
flathead screws M10
Secure the door operator to
the fixing brackets by using
2 flathead screws M10
WARNING
Secure the screws

4.4 ACCESSORIES

4.4.1 HANDRAIL
Prearrange the rear angles, by
drilling at a height of 960 mm
from car floor.
Secure the handrail using 4
flathead screw M4.
4.4.2 APRON
Secure the apron using 3
Socket flat head screw M4.
4.4.3 APRON FOR GL 81 21 LIFT
The car apron is a special feature and is made in two different parts and
an electrical switch :
A) The upper still part that is fixed to the sill in the same way of the
standard apron.
B) The lower mobile part that permit to the lift to reach the lower landing
floor in spite of the pit height dimension is minor than the height of the
extended apron.
C) The electrical safety switch ( CGR on S.e.a. scheme)
Secure the apron using 5 Socket flat head screw M4.
WARNING
To prevent any damage or injury, is compulsory, on the apron is placed an electrical safety switch that
stop the upward movement of the lift 1 m over the lower floor level, if the apron mobile part do not return
in the correct position.
Installation Manual
Car and door operator
Pag. 7 di 8
4
Doc. n° 10991012
Par. n° 10991112
Rev.1.0.6 - 21.12.2005
EN
8