GMV GL MRL–MC Manuel D'installation page 15

4.2.3 WALL IN FRONT OF THE COLUMN (THREE PANELS BUILT)
Lay the ventilated lower baseboard (1) on the side
near the car frame uprights, inserting it on the hex.-
head locking screws M8, sticking to the angle.
Presecure the lower baseboard (1) by using the 3
hex.-head locking screws M8.
Lay the column side panel (2) on the lower baseboard,
inserting it in the ply of the angle edge (1)
Lay the "false column" panel (3) on the lower
baseboard, inserting column side panel (2) in the ply
of the edge
Lay the column side panel (4) on the lower baseboard,
inserting it in the ply of the edge of column panel (3)
Lay the entrance upright (5) on the side near to the
car frame, inserting, it on the hex.-head locking screws
M8 and the column side panel (4) in the ply.
Push towards the opposite rear angle sticking
correctly all the parts (1-2-3-4-5)
Preecure the entrance upright (5) by using the 2 hex.-
head locking screws M8.
WARNING
Verify that all soundproofing strips are correctly placed on the wall panels or in the ply of the entrance
uprights.
4.2.4 PUSH-BUTTON WALL
Lay ventilated lower baseboard (1), on the side
opposite to the car frame uprights, inserting it on the
hex.-head locking screws M8, sticking to the rear
angle.
Presecure the lower baseboard (1) by using the 3
hex.-head locking screws M8.
Lay the column side panel (2) on the lower baseboard,
inserting it in the ply of the angle edge (1)
Lay the push-button column (3) on the lower
baseboard, inserting panel (2) in the ply of the edge
Lay the column side panel (4) on the lower baseboard,
inserting it in the ply of the column edge (3)
Lay the entrance upright (5) on the side near to the
car frame, inserting, it on the hex.-head locking screws
M8 and the column side panel (4) in the ply.
Push towards the opposite rear angle sticking
correctly all the parts (1-2-3-4-5)
Presecure the entrance upright (5) by using the 2
hex.-head locking screws M8.
WARNING
Verify that all soundproofing strips are correctly placed on the wall panels or in the ply of the entrance
uprights or column.
Installation Manual
Car and door operator
Pag. 5 di 8
4
Doc. n° 10991012
Par. n° 10991112
Rev.1.0.6 - 21.12.2005
EN
8