GMV GL MRL–MC Manuel D'installation page 14

4.2 WALLS
4.2.1 REAR WALL
Lay the closed lower baseboard (1) on the side
opposite to the door, inserting it on the hex.-head
locking screws M8.
Secure the lower baseboard (1), in the middle of the
rear side, by using the 3 hex.-head locking screws M8.
Lay the rear angle (2) on the floor corner, on the side
opposite to the car frame uprights and to the door,
inserting it on the hex.-head locking screws M8.
Presecure the rear angle (2) by using the 2 hex.-head
locking screws M8.
Verify that all soundproofing strips are correctly
placed on the wall panels or in the ply of the rear
angle.
Lay the rear panel (3) on the lower baseboard,
inserting it in the ply of the angle edge (1)
Lay the rear angle (4) on the floor corner, on the side
near to the car frame uprights, inserting it on the hex.-
head locking screws M8 and the rear panel (3) in the
ply.
Push towards the opposite rear angle (1) sticking
correctly all the parts (1-2-3-4)
Presecure the rear angle (4) by using the 2 hex.-head
locking screws M8.
WARNING
Verify that the rear angles are correctly placed by checking the dimensions of the trimming of corners.
4.2.2 WALL IN FRONT OF THE COLUMN (ONE PANEL)
Lay the ventilated lower baseboard (1) on the side
near the car frame uprights, inserting it on hex.-head
locking screws M8, sticking to the angle (1)
Presecure the lower baseboard (1) by using the 3
hex.-head locking screws M8.
Lay the complete wall panel (2) on the lower
baseboard, inserting it in the ply of the angle edge (1)
Lay the entrance upright (3) on the side near to the
car frame, inserting, it on the hex.-head locking screws
M8 and the complete wall panel (2) in the ply.
Push towards the opposite rear angle sticking
correctly all the parts (1-2-3)
Presecure the entrance upright (3) by using the 2
hex.-head locking screws M8.
Installation Manual
Car and door operator
(See image ð)
Pag. 4 di 8
4
Doc. n° 10991012
Par. n° 10991112
Rev.1.0.6 - 21.12.2005
EN
8