Louisiana Grills BLACK LABEL 10638 Manuel Du Propriétaire page 18

18
Er1 Error Code
ErH Error Code
Err Error Code with FAN
Error Code Blinking
Err Error Code with
IGNITOR Error Code
Blinking
Err Error Code with AUGER
Error Code Blinking
Err Error Code with PELLET
Error Code Blinking
LOUISIANA GRILLS
Grill probe is not making a Check for damage to the grill probe. Follow care and maintenance instructions if
connection dirty. If all appears in working order, check the connection to the digital Control
Board. Unplug unit from power source. Remove hopper access panel (see electric
wire diagram for diagram). Locate the white wires of the grill probe. Disconnect the
spade connectors, then reconnect until it clicks. Replace the hopper access panel.
The unit has overheated, Unplug unit from power source and allow to cool. Follow care and maintenance
possibly due to grease fire instructions. Remove ashes and unburnt pellets from burn grate and bottom of the
or excess fuel grill. Check burn grate for proper positioning. Check proper positioning of cooking
components. After maintenance, plug unit into power source and press the power
button to turn the unit on. If error code is still displayed, contact customer service.
Fan is not making a Unplug unit from power source. Remove hopper access panel (see electric wire
connection diagram for diagram). Locate the blue and white wires of the fan. Check fan blades
for damage. Follow care and maintenance instructions if dirty. Disconnect the
spade connectors, then reconnect until it clicks. Replace the hopper access panel.
If error code is still displayed, contact customer service.
Igniter is not making a Unplug unit from power source. Remove hopper access panel (see electric wire
connection diagram for diagram). Locate the red and white wires of the igniter. Disconnect the
spade connectors, then reconnect until it clicks. Replace the hopper access panel.
If error code is still displayed, contact customer service.
Auger motor is not making a Unplug unit from power source. Remove hopper access panel (see electric wire
connection diagram for diagram). Locate the yellow and white wires of the auger motor.
Check auger motor and bracket for damage. Disconnect the spade connectors,
then reconnect until it clicks. Replace the hopper access panel. If error code is still
displayed, contact customer service.
Lack of fuel, poor fuel Check hopper to check that fuel level is sufficient, and replenish if low. Should
quality, obstruction in feed the quality of wood pellets be poor, or the length of the pellets too long, this may
system cause an obstruction in the feed system. Remove pellets and follow care and
maintenance instructions.