Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Gas Supply Connection Requirements
� The gas pipe that comes out through the rear of your dryer has
a 3/8" male pipe thread.
� Use an elbow and a 3/8" flare x 3/8" NPT adapter fitting
between the flexible gas connector and the dryer gas pipe, as
needed to avoid kinking.
� Use only pipe-joint compound. Do not use PTFE plumber's
tape.
� This dryer must be connected to the gas supply line with a
listed flexible gas connector that complies with the standard for
connectors for gas appliances, ANSI Z21.24 or CSA 6.10.
Burner Input Requirements
Elevations above 2,000 ft (610 m)
� When installed above 2,000 ft (610 m), a 4% reduction of the
burner BTU rating shown on the model/serial number plate is
required for each 1,000 ft (305 m) increase in elevation.
Gas supply pressure testing
� The dryer must be disconnected from the gas supply piping
system during pressure testing at pressures greater than
1/2 psi (3.45 kPa).
INSTALLATION INSTRUCTIONS
Install Leveling Legs
WARNING
Excessive Weight Hazard
Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
1. Prepare dryer for leveling legs
To avoid damaging floor, use a large flat piece of cardboard
from dryer carton; place under entire back edge of dryer.
Firmly grasp dryer body (not console panel) and gently lay
dryer down on cardboard.
2. Screw in leveling legs
Leveling leg with
diamond marking
Using a wrench and tape measure, screw leveling leg into leg
holes until bottom of foot is approximately 1/2" (13 mm) to
1
1
/
" (38 mm) from bottom of the dryer.
2
For leveling legs with the diamond marking:
Screw legs into leg holes by hand. Use a wrench to finish
turning legs until diamond marking is no longer visible.
Place a carton corner post from dryer packaging under each
of the two dryer back corners. Stand the dryer up. Slide the
dryer on the corner posts until it is close to its final location.
Leave enough room to connect the exhaust vent.
For mobile home use:
Gas dryers must be securely fastened to the floor.
Mobile home installations require a Mobile Home Installation
Hold-Down Kit (PN 346764A). For ordering information, please
reference the Quick Start Guide.
Leveling leg without diamond
marking
11
Publicité
Table des Matières
