Les langues disponibles

Les langues disponibles

Liens rapides

IMPORTANT INSTRUCTIONS -
AK150D, AK150DH,
AK150DG, AK150DG
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN
THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY
INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL
When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock and
WARNING:
OF FIRE, ELECTRIC SHOCK AND INJURY TO
PERSON, OBSERVE THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer.If you have
questions, contact the manufacturer.
b) Before servicing or cleaning the unit, switch power off at service
panel and lock the service disconnecting means to prevent power
from being switched on accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
WARNING:
OF FIRE, ELECTRIC SHOCK AND INJURY TO
PERSON, OBSERVE THE FOLLOWING:
a) Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-related construction.
b) Sufficient air is needed for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment to prevent
back drafting. Follow the heating equipment manufacturer's guideline
and safety standards such as those published by the National Fire
Protection Association (NFPA) and the American Society for Heating,
Refrigeration, and Air Conditioning Engineers (ASHRAE), and the local
code authorities.
c) When cutting or drilling into wall or ceiling, do not damage electrical
wiring and other hidden utilities.
6727930 Rev. E 11-18
All manuals and user guides at all-guides.com
OPERATING MANUAL
INJURY AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
GENERAL SAFETY INFORMATION
injury to person, including the following:
TO REDUCE THE RISK
TO REDUCE THE RISK
SAVE THESE INSTRUCTIONS
CAUTION:
DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE
MATERIALS AND VAPORS.
d) Ducted fans must always be vented to the outdoors.
e) If this unit is to be installed over a tub or shower, it must be marked
as appropriate for the application and be connected to a GFCI (Ground
Fault Circuit Interrupter) – protected branch circuit.
f) This unit must be grounded.
g) To avoid motor bearing damage and noisy and/or unbalanced impellers,
keep drywall spray, construction dust, etc. off power unit.
h) Read all instructions before installing or using exhaust fan.
i)
Suitable for use with electronic speed control device.
WARNING:
WARNING:
OUTSIDE OF THE BUILDING HAS A STRONG EFFECT
ON THE AIR FLOW, NOISE AND ENERGY USE OF THE FAN. USE
THE SHORTEST, STRAIGHTEST DUCT ROUTING POSSIBLE FOR
BEST PERFORMANCE, AND AVOID INSTALLING THE FAN WITH
SMALLER DUCTS THAN RECOMMENDED. INSULATION AROUND
THE DUCTS CAN REDUCE ENERGY LOSS AND INHIBIT MOLD
GROWTH. FANS INSTALLED WITH EXISTING DUCTS MAY NOT
ACHIEVE THEIR RATED AIRFLOW.
www.airkinglimited.com
Exhaust Fan
FOR GENERAL VENTILATING USE ONLY.
DO NOT USE IN KITCHENS.
THE DUCTING FROM THIS FAN TO THE
1 of 12
Table des Matières
loading

Sommaire des Matières pour AirKing AK150D

  • Page 7: Ventilateur D'évacuation

    All manuals and user guides at all-guides.com INSTRUCTIONS IMPORTANTES – MODE D’EMPLOI AK150D, AK150DH, Ventilateur d’Évacuation AK150DG, AK150DG LIRE ET CONSERVER CES INSTRUCTIONS LIRE SOIGNEUSEMENT AVANT DE TENTER D’ASSEMBLER, INSTALLER, OPÉRER OU DE RÉPARER LE PRODUIT DÉCRIT. PROTÉGEZ VOUS-MÊME ET LES AUTRES EN OBSERVANT TOUTE L’INFORMATION DE SÉCURITÉ.
  • Page 8 All manuals and user guides at all-guides.com SECTION 4 INSTRUCTIONS D’INSTALLATION Conduits ATTENTION : VOUS ASSURER QUE L’ALIMENTATION NOTE: UN CONDUIT PLUS RIGIDE DE 6 PO OU PLUS EST RECOMMANDE POUR UNE EST COUPÉE AU PANNEAU DE SERVICE AVANT DE COMMENCER MEILLEURE PERFORMANCE.
  • Page 9: Couvercle Du Compartiment De Câblage

    All manuals and user guides at all-guides.com Noir Noir Couvercle du Neutre (Blanc) Neutre (Blanc) Compartiment Vert Mise à la terre (vert ou nu) de Câblage Figure 5 Par d’autres Figure 9 Compartiment de Câblage Intérieur: Enlever les trois vis retenant en place l’assemblage de la soufflante et soulever pour sortir l’assemblage hors du châssis (Figure 6).
  • Page 10: Modèles Standards

    All manuals and user guides at all-guides.com MODÈLES DÉTECTION DE MOUVEMENT: Installez la grille en pressant le ressort le plus Modèles standards Modèles avec détection loin possible du détecteur de mouvement et installez-le dans la fente la plus éloignée d’humidité du compartiment de fil sur le logement du ventilateur.
  • Page 11: Guide De Dépannage

    All manuals and user guides at all-guides.com Réglez le cadran à l’humidité relative que vous vous voulez que le ventilateur maintienne, habituellement entre 50% et 80%. Les climats humides exigeront des réglages plus élevés que les climats secs. Lorsque le niveau d’humidité de la salle est inférieur à...
  • Page 12: Diagramme Des Pièces De Remplacement

    Bride du plafond 5S1202050 Canal de montage 5S1202123 Assemblée de la Soufflante 5S2239008 Harnais de fusible 5S1999200 Particularités des modèle AK150D # de pièce de Qté. Description remplacement Grille 5S1202048 Assemblée du compartiment du fil 5S1202636 Particularités des modèle AK150DG # de pièce de...

Ce manuel est également adapté pour:

Ak150dhAk150dg

Table des Matières