cecotec PERFECT FIX 360 FREESTYLE Manuel D'instructions page 59

the battery level is low.
- Do not use the appliance while the battery is charging.
- A new battery will develop its full ampere-hour capacity after 5 complete charge/discharge
cycles.
WARNING: charge the silicone gun battery only with the charger supplied.
The heater component of the product is manufactured with a positive temperature coefficient
(PTC), which can heat up very fast and control the temperature automatically. The temperature
cannot increase beyond the maximum temperature for which the appliance was designed,
which prevents damage to the appliance itself, thus expanding its lifespan.
1. Ensure that the work area is clean and safe.
2. Verify that the surface to which you will apply the glue is clean, dry and free of grease
or other contaminants that may affect the adhesive's adhesion.
3. Make sure the battery is charged.
4. Insert the glue stick into the rear hole of the gun.
5. Wait 15 seconds to 1 minute for the glue to warm up. Then, squeeze the trigger until
the melted glue starts to come out of the nozzle. It is equipped with intelligent
fixation. By simply pressing the trigger, the gun projects an endless and continuous
amount of silicone without the need to touch anything or press again.
6. If the glue stick is consumed, you can insert another glue stick without any problems.
Don't worry about residual glue inside the gun; it will cool down and re-melt on the
next use.
7. When you have finished using the gun, unplug it and allow it to cool before storing it.
Warning
1. This glue gun works by using high temperatures to melt the glue sticks, so the nozzle
and the melted glue is extremely hot (up to 200 ºC).
2. Never touch the nozzle while the gun is in use or immediately after unplugging it, as
it will keep hot for several minutes.
3. Never touch the molten glue emitted by the glue gun until it has cooled completely.
4. Be extremely careful when using this appliance, otherwise you may get burned.
4. CLEANING AND MAINTENANCE
Maintenance
While the appliance is not being used, you must store it following these instructions:
- The room temperature must be lower than 40 ºC.
- It must be dry, moisture-free and protected from cold and heat.
ENGLISH
PERFECT FIX 360 FREESTYLE
59