A.2 Certificats Et Homologations; Contrat De Licence Pour Le Logiciel Livré; Homologations Pour Les Usa, Le Canada Et L'australie - Sécurité Du Produit - Siemens SIMATIC IPC827C Instructions De Service

Masquer les pouces Voir aussi pour SIMATIC IPC827C:
Table des Matières

Publicité

Annexes

A.2 Certificats et homologations

A.2
Certificats et homologations
Certificat ISO 9001
Le système d'assurance de la qualité de l'ensemble de notre processus de production
(développement, fabrication et commercialisation) satisfait aux exigences de la norme ISO
9001:2000.
Cela nous a été confirmé par le DQS (= société allemande de certification de systèmes
d'assurance de la qualité) :
certificat Q-Net nº : DE-001108 QM
Contrat de licence pour le logiciel livré
L'appareil est livré avec logiciel installé. Veuillez respecter le contrat de licence
correspondant.
Homologations pour les USA, le Canada et l'Australie – Sécurité du produit
L'appareil possède l'homologation suivante :
CEM
USA
Federal Communications
Commission
Radio Frequency
Interference Statement
Shielded Cables
Modifications
Conditions of Operations
208
Underwriters Laboratories (UL) selon Standard UL 60950-1, Report E11 5352 et la
norme canadienne C22.2 No. 60950-1 (I.T.E) ou selon UL508 et C22.2 No. 142
(IND.CONT.EQ)
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Shielded cables must be used with this equipment to maintain compliance
with FCC regulations.
Changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Instructions de service, 09/2011, A5E03396002-02
SIMATIC IPC827C

Publicité

Table des Matières
loading

Table des Matières