Operating Elements And Connections; Safety Notes - Monacor AVSET-400COL Mode D'emploi

Please unfold page 3. Then you can always see the
operating elements and connections described.
Contents
1

Operating Elements and Connections . . . . . 7

1.1 Receiver (rear side) . . . . . . . . . . . . . . . . . . . . . . 7
1.2 Camera with bracket . . . . . . . . . . . . . . . . . . . . . 7
2

Safety Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

3 Applications . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
3.1 Approval . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
4 Presetting of the Units . . . . . . . . . . . . . . . . . . 8
4.1 Setting of the transmitting channel . . . . . . . . . . 8
4.2 Setting of the receiving channels . . . . . . . . . . . 8
5 Placing of Receiver and Camera . . . . . . . . . . 8
6 Connection of the Units . . . . . . . . . . . . . . . . . 8
6.1 Monitor or video recorder . . . . . . . . . . . . . . . . . 8
6.2 Power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
7 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
7.1 Aligning of the camera . . . . . . . . . . . . . . . . . . . . 8
7.2 Automatic picture sequence switching . . . . . . . 8
8 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . 9
1 Operating Elements and Connections
1.1 Receiver (rear side)
1 DIP switches to select the receiving channels (1 ... 4)
2 Video output (phono jack)
3 Audio outputs (phono jacks, R/L)
4 Jack DC 9V to connect the supplied power supply
unit
5 On/off switch
1.2 Camera with bracket
6 Lens with fixed focal length
7 DIP switches to select the transmitting channel
(on the lower side; protected by a rubber plug)
8 Setscrews for the inclination angle of the camera
9 Microphone opening (on the lower side)
10 Bracket for wall or ceiling mounting
11 DC inline jack to connect the supplied plug-in
power supply unit
2 Safety Notes
The units (receiver, camera, and power supply units)
correspond to the directive 89/336/EEC for electro-
magnetic compatibility. In addition, the power supply
units correspond to the low voltage directive
73/23/EEC.
The power supply units use dangerous mains volt-
age (230 V~). To prevent a shock hazard, do not
open these units! Leave servicing to authorized,
skilled personnel only. Besides, any guarantee claim
expires if receiver, power supply unit, or camera has
been opened.
It is essential to observe the following items:
Protect the units against heat and excessive cold
(admissible ambient temperature range 0 - 40 °C).
The receiver and the power supply units are only
suitable for indoor use. Protect them against humid-
ity.
The heat being generated in the receiver has to be
removed via air circulation. Therefore, the circula-
tion vents at the housing must not be covered with
any objects. Do not insert or drop anything into the
circulation vents! The unit may be damaged.
The camera housing is splashproof but not abso-
lutely watertight. Therefore, do not immerse the
camera in water.
Do not set the receiver or the camera into operation,
and immediately disconnect the power supply unit
from the mains if:
1. damage at the receiver, at the camera, or at the
power supply unit can be seen,
2.a defect might have occurred after a drop or simi-
lar accident,
3. there are malfunctions.
The units must in any case be repaired by author-
ized personnel.
For cleaning of the receiver and the power supply
units only use a dry, soft cloth, by no means chemi-
cals or water. Do not clean the camera housing with
strong detergents or chemicals.
If the units are used for purposes other than orig-
inally intended, if they are not connected or operated
correctly or not repaired in an expert way, there is no
liability for possible damage.
If the units are to be put out of operation definitively,
take them to a local recycling plant for disposal.
GB
7