Eneo VKCD-1323/IR Mode D'emploi page 20

5. 3-Axis Gimbal Adjustments
. First Pan: Turning the first pan by hand for 360° rotation (see figure, No. ).
. Tilt: Adjust the tilt to move up and down by hand (see figure, No. 4).
3. Second Pan: Loosen the pan screw (see figure, No. 3) to adjust the pan to desired angle (see figure, No. ), and
fix the screw (see figure, No. 3).
Zoom lever (No. 5)
Second pan (No. )
Pan screw (No. 3)
6. Zoom & Focus Adjustment
. If you require to make focal / focus adjustments, pull the outer lever and make necessary adjustments.
. Pull out Zoom & Focus Levers, release and make the viewing angle / focus as shown.
• Field of View: Telephoto (T) to Wide (W)
• Focus: Near (N) to Infinity ( )
3. After the adjustments, fix Zoom & Focus Levers
and push the outer lever back in.
CAUTION: Unless the outer levers push back in properly,it touches inside the bubble and causes scratch.
Focus lever (No. 6)
Tilt (No. 4)
First pan (No. )
Focus lever
0
Zoom lever