Checking The Installation; Display Window - Hoist Fitness LeMond pilot II Manuel D'instructions

INSTALLATION OF PILOT
3. Secure the transmitter to the bike with two M4 x 40
screws; tighten with a 3 mm hex key.
4. Reinstall the transmitter battery cover and screw;
tighten with a 2.5 mm hex key.

Checking the Installation:

1. Turn the console on by pressing START.
2. Rotate the cranks for 10 seconds and verify that the con-
sole is detecting up the crank rotation and displaying
RPM's in the cadence section of the display window.
3. If you do not see RPMs in the display window, press
the [CADENCE] key repeatedly until "INST" RPM
is shown in the display window. If RPM still does
not show, refer to the troubleshooting section of this
manual.
Page 11