Adjusting The Grinding Unit - NEFF CV 7760 N Mode D'emploi

: EaМС tТmО a ЧОа аatОr i ХtОr
Water filter
is inserted in the water tank (8), it must be
rinsed:
PХaМО tСО аatОr i ХtОr ТЧ tСО аatОr taЧФ
1.
(8) aЧН i ХХ tСО taЧФ аТtС аatОr up tШ tСО
"max" mark.
2. Use the navigation button
START and press
3. Place a container with a capacity of 0.5
litres under the milk frother (19).
(6). АatОr аТХХ ЧШа ruЧ i rst
4. Press
tСrШuРС tСО i ХtОr tШ rТЧsО Тt aЧН tСОЧ ТЧtШ
the container.
Empty the container. The appliance is ready
to use once more.
TСО i ХtОr Тs ЧШ ХШЧРОr ОППОМtТvО аСОЧ tСО
Change filter display appears, or at the
latest after two months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
НamaРО tСО appХТaЧМО). RОpХaМОmОЧt i ХtОrs
can be obtained from retailers or customer
service (see "Accessories").
AПtОr ОvОrв i ХtОr МСaЧРО tСО i ХtОr must i rst
be rinsed. Proceed as described at the
beginning of this section.
IП ЧШ ЧОа i ХtОr Тs usОН, turЧ tСО аatОr i ХtОr
setting to Off .
If the appliance has not been used
for a prolonged period (e.g. during
вШur vaМatТШЧ) tСО i ХtОr sСШuХН
be rinsed before the appliance
is used again. To do this, simply
dispense a cup of hot water.
Neff
to select
(6).
Further entries in the Settings menu:
Service - descale
the appliance, press
descaling programme (see "Descaling").
Service - clean : If you want to clean the
appliance, press
ing programme (see "Cleaning").
Service - Calc'n'Clean
scale and clean the appliance at the same
time, press (6) and run the Calc'n'Clean
programme (see "Calc'n'Clean").
Factory settings
settings and reset the factory settings. To
activate the factory settings, press
The appliance can also be reset
to the factory settings as follows:
1. Switch the appliance off fully at the
power switch O/I
2. Press (2) and
time, hold them down, and switch the
appliance on again at the power switch
O/I (7).
The factory settings are reactivated.

Adjusting the grinding unit

The rotary selector (11) on the top of the
appliance adjusts the degree of grinding
ПrШm МШarsО tШ i ЧО as rОquТrОН.
11
Warning:
Adjust the grinding unit only while
it is running. Otherwise the appli-
ance may be damaged.
English | 35
: If you want to descale
(6) and run the
(6) and run the clean-
: If you want to de-
: You can cancel your own
(7).
(5) at the same
C77V60N01 | 09/2008
(6).