Manual Satellite Update Function - SELFSAT Snipe Dish Séries Manuel De L'utilisateur

e. Software upgrade takes about 10 seconds
f. When the upgrade is completed, all Satellite LEDs flash once, then HOME / Lock /
DiSEqC LED is off, controller is rebooted
g. When HOME LED becomes solid this means the antenna is ready to operate
h. If upgrade is failed, HOME / Lock / DiSEqC LEDs blink 5 times and back to the previous
system
※ Use FAT32 format USB only.
※ CBI type USB is not supported.

7-4. Manual satellite update function

In case there is specific satellite with an error, update satellite information manually
with the below instruction.
a. Press the next satellite of the satellite with an error to search
- For Turksat, Astra 2 is only the option
- For Hispasat, Eutelsat 5W is the only option
- For the rest satellites, each has two options on both side
For example :
b. Once the next selected satellite is found (locked), go to the satellite with an error and
press SET button longer than 2 seconds
- Make sure that Lock LED blinks quicker than per second while update
If the button is pressed less than 2 seconds, Lock LED blinks as normal operation
c. If update is succeeded, all satellite LEDs blink twice and automatically start to search the
satellite
d. If update is failed, antenna goes back to HOME position
- Select the another option of next satellites and proceed update as the above procedure
again
- If second trial is failed, check the manual for software upgrade
※ If upgrade or factory reset is applied, all stored data will be removed.
ENGLISH - 19