Maintenance; Nozzle Maintenance; General Maintenance - Arctic Cove MLT0180 Manuel D'utilisation

MOVING THE MUSIC, MISTING, AND LIGHT
TOWER
See Figure 19, page 17.
WARNING:
Securely hold misting tower when moving, do not over tilt
the unit, and only place on a flat, level surface. Improper
movement or placement of the misting tower may cause
it to tip over and result in death or serious personal injury.
Wheels are installed on one side of the base assembly for
ease in relocating the misting tower.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
WARNING:
With the battery pack removed from the product, always
clean and thoroughly dry out all parts of the misting hose
assembly, and water tubes when not in use to prevent
the possible formation of bacteria or mold. Spraying
mist that contains bacteria or mold can result in serious
personal injury or illness.
OPERATION
Always move the unit to a level surface and make sure it is
in a stable position. Never place the tower in any position
other than upright.
To move the tower:
 Remove the water bucket and securely close the door of
the base assembly.
 Remove the battery pack and close the battery compart-
ment cover.
 Grasp the center pole and carefully tilt the tower toward
you slightly until it balances on the wheels, then roll the
tower to the desired position. Do not tilt forward or side-
ways when moving.
 When the tower is in the desired location, carefully set
the tower upright.

MAINTENANCE

NOZZLE MAINTENANCE

See Figure 20, page 17.
WARNING:
Ensure all nozzle maintenance is properly performed
to prevent leaks. Leaks can result in a slippery surface,
create a slip and fall hazard, or cause property damage.
Irregular mist patterns or leakage may be the result of a
clogged or dirty nozzle.
To clean nozzles:
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1 when performing these mainte-
nance steps. Failure to do so could result in objects being
thrown into your eyes, resulting in possible serious injury.
 Remove the battery pack.
 Remove the brass nozzles.
 Soak nozzles in Arctic Cove nozzle cleaner (not included,
MACC008) to loosen foreign materials clogging or
restricting the nozzle.
 Using a garden hose, flush debris out of nozzle by back
flushing (running the water through the nozzle backwards
or from the outside to the inside).
 Reconnect the nozzles.
9 — English