Fcc Compliance - Arctic Cove MLT0180 Manuel D'utilisation

BLUETOOTH LICENSE STATEMENT
®
The BLUETOOTH word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such
®
marks by TECHTRONIC POWER TOOLS TECHNOLOGY LIMITED is under license. Other trademarks and trade names are
those of their respective owners.

FCC COMPLIANCE

WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible
for compliance. Such modifications could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two con-
ditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the an-
tenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
The applicant is responsible for providing proper instructions to the user of the radio device, and any usage restrictions,
including limits of exposure durations. The user manual shall provide installation and operation instructions, as well as any
special usage conditions, to ensure compliance with SAR and/or RF field strength limits. For instance, compliance distance
shall be clearly stated in the user manual.
The user manual of devices intended for controlled use shall also include information relating to the operating characteris-
tics of the device; the operating instructions to ensure compliance with SAR and/or RF field strength limits; information on
the installation and operation of accessories to ensure compliance with SAR and/or RF field strength limits; and contact
information where the user can obtain Canadian information on RF exposure and compliance. Other related information
may also be included.
CALIFORNIA PROPOSITION 65
WARNING:
This product and substances that may become airborne from its use may contain chemicals, including lead, known to
the State of California to cause cancer, birth defects, or other reproductive harm. Wash hands after handling.
11 — English