Setting The Wake Up Timer - Teac SR-LUXi Mode D'emploi

Wake Up Timer (1)
The unit can be programmed to turn on at a specified
time. It can also be set to brighten the light gradually
before the set time. You can set the unit to play an iPod/
iPhone, FM radio or a buzzer sound.
If the sound source is set to iPod or FM
When the set time is reached, the power of audio
section is turned on. 60 minutes later, the power turns
to standby (off) again.
If the sound source is set to buzzer
When the set time is reached, the buzzer sounds for
5 minutes and then the unit turns to standby (off)
again.

Setting the Wake Up Timer

Press and hold the ALARM button for more than
1
3 seconds.
The clock on the display and the ALARM button blink.
< If you do not press the button for 8 seconds, the
wake up timer setting mode ends automatically.
Use the VOLUME buttons (+ and −) to set the
2
hour and minute.
< Pressing a VOLUME button (+ or −) once causes
the time to change by 5 minutes. Press and hold a
button to make it change more quickly.
Press the ALARM button.
3
The name of the selected source appears on the
display.
22
< Adjust the clock before setting the
timer (page 11).
< The wake up timer can be set in
5-minute increments.
< T h e l i g h t c a n b e s e t to s t a r t
becoming brighter either 10 or 30
minutes before the set time. The
light can also be set to stay off.
Hold down
more than 3 sec.