Descaling - DS Produkte Z 08018_V3 Mode D'emploi

Descaling

CAUTION!
❐ The device needs to be descaled, if it is operated with tap water instead of distilled water.
❐ Remove the plug from the mains socket before cleaning or descaling the device.
❐ After use, the device may still be very hot. Allow the device to cool down completely
before descaling it.
❐ Never fi ll descaling agents into the water tank. This may cause damage to the device.
1. You will fi nd a triangular metal plate on the ceramic iron
plate (steam outlet). Insert a screw driver into the provided
notch on the iron plate and lift out the metal plate. Be ca-
reful, wehn lifting out the metal plate. Do not damage the
ceramic iron plate!
2. Loosen the three screws of the steam fi lter with an appro-
priate screwdriver.
3. Take out the steam fi lter and clean it by hand or with an
standard commercial descaling agent. If using a descaling
agent, follow the manufacturer's instructions for descaling.
4. Let the steam fi lter dry completely before inserting the
steam fi lter back into the iron plate.
5. Insert the steam fi lter in the ceramic iron plate and tighten
the screws with an appropriate screw driver.
NOTE: Before inserting the steam fi lter, make sure that
the O-ring sits correctly in the circular groove on the iron
plate.
6. Place the metal plate back into the iron plate. First, align
the fl at side of the metal plate with the groove on the iron
plate. Then, press down the entire plate, Make sure, that
the metal plate clicks correctly into place.
25