Cleaning; Engine; Engine Oil Exchange - Zipper Maschinen ZI-MD500HST Mode D'emploi

14.2 Cleaning

Clean the machine and the working attachment from soil, dust, grass, chips, and small twigs, etc.
The use of solvents, harsh chemicals or abrasive cleaners leads to damage to the machine!
Therefore: When cleaning, use only mild detergent
The use of high pressure cleaners is not recommended. It shortens the service life and reduces the
operational integrity. (Water can get into the gear!)
Impregnate bare surfaces of the machine against corrosion (e.g., anti-rust WD40)

14.3 Engine

Information about engine maintenance you can find in operation manual of the engine manufacturer!
14.3.1

Engine oil exchange

The engine oil change would be explicitly mentioned here in order to be included in the machine
operating manual. Oil change interval after the first 20h or 1 month after commissioning and then
every 100h or 1x per year.
Waste oils are toxic and must not be released into the environment!
Contact your local authorities for information on proper disposal.
ZIPPER MASCHINEN GmbH
ZI-MD500HST
1. Remove the oil drain plug (1) from the engine.
2. Open the oil tank cap (2). Collect the draining oil in a
3. Retighten the oil drain plug after draining.
4. Fill in fresh oil through the filling opening (3) (see
5. Use only high quality engine oil, e.g: SAE30, 15W40 or
www.Zipper-Maschinen.at
NOTICE
NOTICE
collection container and dispose of it properly.
section Checking the engine oil level).
similar!
Drain the used oil when the engine is warm.
Warm oil drains quickly and completely.
MAINTENANCE
NOTICE
36