Schweizer eMag 43 Mode D'emploi page 25

The battery indicator LED is flashing red.
The battery LED is solid red while the
power adapter is connected to the
eMag 43.
The battery indicator LED does not flash
green, even though the power adapter is
connected and plugged into a wall socket.
The NiMH batteries are not charging.
There are smudges or blemishes on the
screen.
The text is too small to read.
The text is too large to read.
Charge the NiMH batteries, or, if using AAA alkaline batteries,
replace the alkaline batteries. (Do not mix NiMH and alkaline
batteries.)
A battery error has occurred. Unplug the power adapter from
the eMag 43 and plug it in again. Charge the NiMH batteries
for at least 2 hours. If using AAA alkaline batteries, replace the
alkaline batteries. If the problem continues, disconnect the
power adapter and call your eMag 43 merchant.
Ensure that the small end of the power adapter is properly plugged
into the unit's power port.
Ensure that the outlet has power and is not malfunctioning. If the wall
outlet is connected to a wall switch, make sure that the switch is on.
Ensure that the small end of the power adapter is properly
plugged into the unit's power port.Ensure that the batteries are
inserted properly. Observe the correct polarity.Ensure that the
outlet has power and is not malfunctioning. If the wall outlet is
connected to a wall switch, make sure that the switch is on.
Clean the LCD display and the camera window.
Press the yellow Magnification button to increase the
magnification level.
Press the yellow Magnification button to cycle through to
a lower magnification level.
25