Storage; Disposal; Troubleshooting; Technical Specifications - SilverCrest SFS 110 B2 Mode D'emploi

__CPE281169_Folienschweissgeraet_B1.book Seite 47 Dienstag, 20. September 2016 5:17 17
9.2

Storage

WARNING! Risk of material damage!
During storage, the lid 11 must not be
locked, but only loosely closed. Perma-
nent locking could damage sealing
rings 10 and 16.
• Figure C: wind the power cable 6
around the cable spool 17 at the un-
derside of the device.
• Store the device protected against dust
and dirt and out of the reach of chil-
dren.

10. Disposal

This product is subject to the
provisions of European Direc-
tive 2012/19/EC. The sym-
bol showing a wheelie bin
crossed through indicates
that the product requires sep-
arate refuse collection in the European Un-
ion. This applies to the product and all
accessories marked with this symbol. Prod-
ucts identified with this symbol may not be
discarded with normal household waste, but
must be taken to a collection point for recy-
cling electric and electronic appliances. Re-
cycling helps to reduce the consumption of
raw materials and protect the environment.
Packaging
When disposing of the packaging, make
sure you comply with the environmental reg-
ulations applicable in your country.

11. Troubleshooting

If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock!
Do not attempt to repair the device
yourself under any circumstances.
Possible causes /
Fault
• Has the device been
No function connected to the power
supply?
• Ensure that the film is po-
sitioned smoothly be-
tween the sealing strip 9
Seams are
and the welding
wire 14.
not tight
• The film was damp or
contaminated at the
seam.
12. Technical specifica-
tions
Model: SFS 110 B2
Mains voltage: 220-240 V ~ 50/60 Hz
Protection class: II
Power rating: 110 W
Operating at least 80 seconds after
pause: each use
Subject to technical modification.
Action
47
GB