Technical Characteristics; Fluid Characteristics; Electrical Characteristics - ASCO Numatics FlowtronicD 607 Série Manuel D'installation

INSTALLATION
5. FIELD-PROGRAMMABLE SETTINGS (cont'd)
AUTOTUNE
AUTOTUNE determines the forward current the proportional valve needs to open. This control parameter, called forward
offset, is permanently stored.
AUTOTUNE can be activated in the three following ways:
1. Press and hold the AUTOTUNE button, switch the supply voltage off and on again, and release the AUTOTUNE but-
ton.
2. Over the ASCO-FlowCom operating software.
3. If the appropriate option has been selected over the operating software, AUTOTUNE can be activated over the digital
input (M12, Pin 5).
After having determined the forward offset, the device will automatically go into Regular mode.
6.

TECHNICAL CHARACTERISTICS

CONSTRUCTION
Direct operated poppet valve
Body: Aluminium
Internal parts: Aluminium, brass, stainless steel
Seals: NBR
6.1

Fluid characteristics

FLUID
MAX. AIR PRESSURE (MAP)
BAND OF REGULATION (PMR)
TEMPERATURE FLUID
AMBIENT
SETPOINT - ANALOG
FEEDBACK - ANALOG
FLOW ACCURACY
HYSTERESIS
LINEARITY
REPEATABILITY
CALIBRATION CONDITIONS
AMBIENT TEMPERATURE
FLUID
DYNAMIC PERFORMANCE
RESPONSE TIME
OTHER FEATURES
6.2

Electrical characteristics

nominal diameter
voltage *
DN
2, 3, 5 and 6
24 V = +/-10%
8
*
Max. ripple: 10 %
INSTALLATION
Assembly position: any (solenoid upright preferred)
: Air or nitrogen (N ), filtered at 50 µm, without condensate, lubricated or not
2
: 8 bar
: 5 - 2000 l/min (up to max. 6 bar outlet pressure), consult us for other ranges)
: 0° C to +50° C
: 0° C to +40° C
: 0 - 10 V (100 kΩ), 0/4 to 20 mA (resistance 250 Ω)
: 0 - 10 V, 0/4 to 20 mA (max. load 500 Ω)
: ± 3%
: ± 3%
: ± 1,5%
: 22,5°C ±2,5°C
: Air
: < 200 ms
: Auto-tune, error display by 3 LEDs
max. power max. current
(W) (mA)
30 1250
44 1800
degree of protec-
insulation class
tion
- 5 pin M12 connector
H IP65 - USB connection with 4 pin
GB
electrical connection
M12 connector
IM14156-7