Technical Data; Before Starting The Equipment - EINHELL Bavaria BSD 3,6/1 Li Mode D'emploi D'origine

Anleitung_BSD_3_6_1_Li_SPK1__ 15.02.13 11:30 Seite 11

4. Technical data

Motor power supply:
Idling speed:
Clockwise/Counter-clockwise:
Charge voltage for rechargeable battery:
Charge current for rechargeable battery:
Battery charger supply voltage: 230 V ~ 50 Hz
Charging time: max. 5 hours
Battery type:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level 58,8 dB(A)
pA
K uncertainty
pA
L sound power level 69,8 dB(A)
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Screwing without hammer action
Vibration emission value a ≤ 2,5 m/s 2
h
K uncertainty = 1,5 m/s 2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
n
3.6 V DC
order.
200 min -1 Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Yes
Do not overload the appliance.
n
6 V DC
Have the appliance serviced whenever
n
300 mA necessary.
Switch the appliance off when it is not in use.
n
Wear protective gloves.
n
Residual risks
Li-Ion
Even if you use this electric power tool in
0.4 kg
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
3 dB
is not properly guided and maintained.
3 dB

5. Before starting the equipment

Be sure to read the following information before you
use your cordless screwdriver for the first time:
1. Charge the battery pack with the charger
supplied.
2. Only ever use screwdriver bits which are suitable
for the purpose and in faultless condition.
3. Always check for concealed electric cables and
gas and water pipes when drilling and screwing
in walls.
6. Operation
6.1 Charging the battery (Fig. 1)
The battery is protected from exhaustive discharge.
An integrated protective circuit automatically
switches off the equipment when the battery is flat. In
this case the bit chuck will cease to turn.
Warning! Do not press the ON/OFF switch any more
if the protective circuit has actuated. This may
damage the battery.
1. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Plug the battery charger in the plug
socket and connect the charging cable to the
charging connection. The charging process
GB
11