Assembling The Blow Pipe And Control Handle; Optional Equipment - Husqvarna 150BT Manuel D'utilisation

Assembling the blow pipe and
control handle
• Connect the blower and control pipe with the flexible
hose. Clamp both ends of the flexible hose in place.
Use the accompanying hardware.
1
3
1 Flexible hose
2 Control pipe
3 Clamp
4 Clamp
NOTE!
Lubricate the pipes a little to facilitate assembly.
CAUTION! Do not assemble the
!
intermediate pipe before you have
assembled the control handle.
• Fasten the handle holder (A) to the control pipe (B)
and tighten the screw (C) on the holder. Please make
sure to align the handle holder with the convex of the
control pipe.
B
CAUTION! Do not expand the handle
!
holder when you mount it to the control
pipe. This will break the handle holder.
ASSEMBLY
2
4
A
C
• The cabling of the control handle must not be twisted
during assembly.
• Adjust the position, to achieve a comfortable working
position, and tighten.
Fasten the corrugate tube containing the throttle cable
and power cable at the center of the flexible hose using
the supplied clamp.
Blower pipe
Assemble the intermediate pipe to the control pipe, then
attach the blower nozzle to the intermediate pipe. It is
possible to add more intermediate pipes if longer round
blower pipe are required. (Not included in the box).
The blower nozzle can only be connected to the
intermediate pipe.
If higher air speed is required, the blower nozzle is
replaced by the concentrator nozzle.

Optional equipment

(Not included in the box).
• If higher air speed is required, the round blower nozzle
is replaced by the flat nozzle.
–
English 13