Charging Process - kikkaride AXES Mode D'emploi

2. Before You Ride
Before riding, please always make sure
• WEAR PROPER PROTECTIVE GEAR SUCH AS SAFETY HELMET, ELBOW PADS AND KNEE PADS, LONG SLEEVED SHIRT, LONG TROUSERS, GLOVES, LACE UP
SHOES WITH RUBBER SOLES.
• You are in a safe and open area.
• All nuts and bolts are tight.
• Brake is functioning properly.
3. How To Ride
• Turn on the Switch, put one of your foot onto the G-Sensor of footplate, kick the scooter to give it a minimum speed of 5km/h, then it runs!
• If you want to slow down the speed, please tap the brake pad.
• If you want to stop, please keep pressing the brake pad continuously for 3 seconds. Please be aware that the scooter will speed up again if you brake for
less than 3 seconds.
• In case of emergency, you can jump off the scooter, and it still stop running immediately.
• Always remember to power off the switch when not in use.
4. Parameters (Figure 2)
5. Usage of Battery (Figure3)
This section mainly describes the charging method of Axes electric scooter, how to maintain the battery, some security issues, and battery speci ca-
tions.
For users' safety, and the maximum extent of prolonging the battery life and improved battery performance, please follow the following operations
using the battery.
5.1 Battery Power ( Figure 4)
Don't use the battery if the following occurs.
• Emits odor or overheats.
• Don't touch any leaking materials.
• Children and animals are forbidden to touch battery.
• The charger must be taken out before installing or driving or it may cause danger.
• Battery contains dangerous substances, do not open the battery, do not insert anything into the battery.
• Please only use the charger provided with Axes electric scooter.
• The electric scooter battery should be disposed of according to local law.

5.2 Charging process

• Ensure charging port is dry.
• Open the charging port. Plug the charging cable into the Axes electric scooter, then connect the cable with the power supply (100V~ 240V; 50, 60
Hz).The red light indicates that it has begun to charge, otherwise check whether the cable is connected.
• When the indicator light goes from red to green, it indicates that battery is fully charged. At this time, please stop charging, over-charging will a ect
lifetime use.
• Charge and store battery as suggested, otherwise it will damage the battery. The charging time is about 2-3hours.
• Keep the charging environment clean and dry.
6.1 Clean the electric scooter
• Disconnect the charger and turn o the electric scooter.
• Wipe the cover.
• Avoid using water or other liquids on the electric scooter for cleaning. If water or other liquids seep into the electric scooter, it will cause permanent
damage to the internal electronics.
ENGLISH