Dog trace d-control 600 Mode D'emploi page 31

Switching ON
Move the red target on the receiver towards the bottom of the transmitter for 1 second (see the
Fig.). The red LED indicator of the receiver will lit up, afterwards the green LED indicator will lit up
– move the transmitter away from the receiver. The receiver is prepared for use.
Switching OFF
When switching OFF, follow the same steps as when switching ON. Move the red target of the
receiver towards the bottom of the transmitter – the green LED indicator of the receiver will lit up,
afterwards the red LED indicator will lit up.
IMPORTANT: When turning the receiver ON hold the red
target of the receiver close to the red target of the transmitter
for about 1 second. When the targets are close to each other
for longer than 5 seconds the receiver will switch to the
pairing (programming) mode of the transmitter with the
receiver. This programming mode is indicated by flashing of
the green and red LED indicator. If this occurs, follow the
chapter Programming (pairing) the transmitter with the
receiver.
Caution: To extend the battery life, it is necessary to turn off the receiver and transmitter
whenever the training of your dog is finished. If you do not use the device for a long time, we
recommend you to remove the batteries out.
Programming (pairing) of the transmitter and the receiver
Each transmitter has its own RF operational code. The pairing needs to be done to make the
receiver and transmitter operate together. When you receive a new set the pairing is done by
manufacturer. The pairing is done, when you need to use different transmitter or receiver (for
example when bought a new one).
The position where the receiver
is turned ON/OFF and where the
transmitter is being paired with
the receiver.
31