Description Of The Back Panel - Comeg SOPRO 184 Manuel D'utilisation

Description of the back
9
panel
9.1 Mains connectors/Fuses
The video camera is powered via the mains connector fi tted to the back panel [C2], which must be
connected to the mains using the cord provided with the camera. This connector features a fuses
compartment with a cover [F1] as well as the master switch for powering up the device [S9].
When replacing a fuse, you must disconnect the video camera from the mains and use the same type of
fuse. The "T" in "T800mA" stands for "Time-delay". Only use fuses with UL/CSA markings.
9.2 Video outputs
1. Standard:
This video camera features 3 video outputs: a composite output [C9], a Y/C output [C8], and an RGB output
[C7].
A USB2 outlet [C5] which enables your video camera to be connected directly to a PC or to a video recorder.
This will enable you to record video sequences of an operation using any video recording soft ware.
Connect the video camera's USB2 output [C5] to a computer's USB2 input.
Make sure that your PC or recorder complies with the standards in force (IEC 60601-1) and that it
has been authorised for use in an operating unit.
It is prohibited to carry out the operation with the USB2 output; a video output must be connected
to the monitor.
2. Option:
Two SDI outputs enable the video signal to be transmitted over long distances (to a remote screen, etc.).
9.3 Peripheral output
A peripheral output [C6] enables print-outs, screen shots, etc. via a 3.5 mm stereo jack cable, using the
control wheel on the sensor. A «p» will be displayed on the screen when this function is activated from
the head of the video camera.
First of all, you have to confi gure the activation of this output via the Tool menu (cf. section 8.3).
Devices connected to the «VIDEO OUT» and «PERIPHERAL» sockets must comply with the IEC 60950
standard.
9.4 Indications and symbols on the back panel
The indications and symbols on the back panel enable the video camera to be identifi ed in accordance
with the following international standards: IEC 60601-1, IEC 417 and ISO 980 (see section 15).
18 011546C