Separate Shredder For Cd's And Credit Cards - Genie 250CD Mode D'emploi

This device is designed solely for private use in enclosed quarters and for brief
operation not exceeding 2 minutes.
commercial applications nor outdoors.
Furthermore, the document shredder features a "Clear" switch. Please press this if the
shredding operation ends before the paper has been completely shredded. With the help of
the clear switch, the paper is then completely ejected into the waste basket.
Capacity of the document shredder:
The 250 CD shreds up to 7 sheets of paper (DIN A4, 70g). The paper width may comprise up to
22 cm. When shredding small paper sizes such as letters or credit card receipts, please insert
them into the middle of the shredding slot.
Please ensure that never more than the above-mentioned maximum quantity is inserted in the
shredder. Otherwise the device may sustain damage.

Separate shredder for CD's and credit cards:

This document shredder is equipped with a separate shredder for CDs/DVDs and credit cards.
CDs/DVDs are shredded into 4 pieces. Given that such materials always present the risk of
splinters, please keep your face at an acceptable distance when inserting CDs/DVDs. The
shredded material is then collected in a separate tray thereby facilitating its environmentally-
friendly disposal.
Protection against paper jams and overloading:
The 250 CD is equipped with a motor overload guard. The normal work cycle for the shredding
operation takes 2 minutes with a maximum load, after which a prolonged break must be taken.
Under the following conditions, the current feed to the unit's motor is interrupted:
1. Continual operation of the document shredder with maximum capacity for a prolonged
period of time, e.g. longer than 2 minutes without interruption.
2. Overrunning the shredding capacity e.g. adding more than 7 sheets of paper (70g) in one
operation or in the event the paper is not inserted length-wise into the feed slot.
Under the above-mentioned conditions, the automatic overload guard of the motor is triggered,
whereupon the current feed to the device is interrupted. In such a case, please take the
following steps:
1. Disconnect the mains plug from the AC socket and wait at least
overload guard has reset. Now tear off excess paper from the top of the shredder or
- 8 -
Do not use the document shredder for
60 minutes until the